ZTW Beast SL 50A G2 32 Bit Waterproof Sensorless ESC 2S-3S With XT60

ZTW Beast SL 50A G2 32-Bit Waterproof Sensorless ESC 2-3S with XT60 for 1:10 RC Buggy, Truck and RTR Car

Waterproof 50A RTR ESC for 1:10 Bashing

The Beast SL 50A G2 is a 32-bit, fully waterproof sensorless ESC built for 1:10 RTR buggies, trucks, truggies, and monster trucks. Pre-installed connectors and a cooling fan make it a true out-of-the-box power system.

50A Continuous / 300A Burst on 2-3S

Delivers 50A sustained and 300A peak on 2-3S LiPo, driving 3650-size sport motors with smooth acceleration and reliable power for bashing, backyard running, and entry-level club racing.

32-Bit Processor & New Software

The 32-bit microprocessor provides more accurate motor output and better throttle linearity, with smooth startup and strong acceleration that makes 1:10 vehicles predictable and fun to drive.

Completely Waterproof & Dustproof

The fully sealed ESC shrugs off mud, snow, puddles, and dust — run in any weather and any terrain without worrying about water damage.

Pre-Installed Amass XT60 & 4.0mm Bullets

Comes ready to install with an Amass XT60 battery connector and 4.0mm gold bullet motor connectors pre-soldered — no soldering required for most RTR setups.

Cooling Fan & 6V/3A BEC

The integrated cooling fan maintains thermal headroom during extended runs, while the 6V/3A switching BEC delivers clean power to the receiver and steering servo.

LED Card or APP Tuning & Protections

Program via LED Program Card G2 or optional Bluetooth module with the phone APP. Throttle response, drag brake, brake force, and reverse mode are all adjustable — crawler-friendly drag brake and Fwd/Rev modes included. Low-voltage, over-temperature, signal-loss, and stall protection standard.

Technical Specifications