ESC ZTW Skyhawk 130A 6-14S HV SBEC RC Speed Controller Adjustable

ZTW Skyhawk 130A 6-14S HV SBEC Brushless ESC for Fixed-Wing UAV VTOL RC Helicopter

Opens the High-Voltage Skyhawk Line

The 130A HV is the entry point into Skyhawk's 6-14S HV bracket, built for large-scale fixed-wing UAVs and industrial multirotor platforms that run higher-voltage packs for more efficient power delivery and lower current draw.

130A Continuous / 150A Burst Current

Solid burst headroom over continuous output helps the 130A HV absorb hard throttle transients and payload changes on large platforms without tripping protection during demanding mission profiles.

Patented Hollow Heat-Dissipation Structure

A patented case design with openings on both sides and dedicated airflow channels directs cooling air into the ESC's middle layer — solving the mid-layer heat buildup that surface-only fan cooling can miss on long, high-power missions.

Power-On Self-Test for Safer Startups

Every power-up runs an automatic check for short circuits, motor phase loss, throttle-zero position, and voltage range — catching wiring or setup errors before a large-scale UAV or drone platform takes off.

Shares Its Footprint with the 160A HV

At 236g and 95×50×36mm, the 130A HV uses the same housing as the higher-current 160A HV, giving OEMs one ESC bay design that covers two power points in the lineup.

10A Adjustable SBEC

Switchable 6.0V/7.4V/8.4V output at up to 10A runs a flight controller and full servo or actuator set on large-scale platforms without a separate UBEC, even at higher pack voltages.

Bluetooth and LCD Programming with Full Telemetry

Configure speed-governing response, cutoff timing, and BEC voltage via the LCD Program Card G2 or the Bluetooth module app, with real-time current, voltage, temperature, RPM, and status feedback throughout the mission.

Technical Specifications